Re: (PM) Display idle timer from command line

Thomas Kinnen (tkinnen@livingston.com)
Mon, 08 Mar 1999 11:06:39 -0800

"Tim Hodges, Triangle Telephone Cooperative Assoc." wrote:
>
> How can I display the what the idle timer is set to on
> a PM-3. I know the command to set it is:
> set Sx idletime 0-240
>
> But, how can I see what it is set to.

Do a set extended on and then show the port when it is idle:

joan> show s1
----------------------- Current Status - Port S1 ----------
Status: IDLE
Input: 1231694 Parity Errors: 0
Output: 8096362 Framing Errors: 0
Pending: 0 Overrun Errors: 0
Modem Status: DCD- CTS+

Active Configuration Default Configuration
-------------------- ---------------------
Port Type: Login/Netwrk Login/Netwrk (Dial In)
Login Service: Rlogin Rlogin
Baud Rates: 115200 115200,115200,115200
Databits: 8 8
Stopbits: 1 1
Parity: none none
Flow Control: RTS/CTS RTS/CTS
Modem Control: on on
Hosts: default

Terminal Type: vt100
Login Prompt: login:
Idle Timeout: 10 minutes
Dial Group: 0
Login Message: This is a private system. Disconnect now.^
joan> 

-- 
Thomas C Kinnen - <tkinnen@livingston.com> <tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my employer's,
unless they were given to me by my employer"
-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>