> I need to run OSPF and currently have only an OR-HS with 1Mb or ram (can't
> expand, no simm sockets). Will it run without problems?
As long as you're not going to put a big table in it you should be able to
do it.
Here is my OR-AP running OSPF
Command> show mem
System memory 1703936 bytes - 1007736 used, 696200 available
128:2 528:1 80:1 272:3 176:1 16:3 32:10 160:0 48:0
System nbufs 800 - 33 used, 767 available
Command> show modules
Module State Start Len
---------------- ----- ------ ---------
0 SNMP ACT 108ab0 26880
1 IPX HEAP 104940 16752
2 INIT HEAP ff000 22848
3 SYNC HEAP 136a60 16400
4 L2TP HEAP 0 0
5 OSPF ACT 13aac0 55264
6 BGP HEAP 13aa70 80
7 ISDN ACT 10f988 145808
8 ISDN-NORTH-AM ACT 133318 14116
9 ISDN-EUROPE HEAP 136a40 24
10 ISDN-JAPAN HEAP 136a58 8
Command>
-- Thomas C Kinnen - <tkinnen@ra.lucent.com> <tkinnen@sobhrach.com> [RADIUS Test Engineer] - LUCENT Technologies RABU "All of the opinions stated above are my own and not my employer's, unless they were given to me by my employer"- To unsubscribe, email 'majordomo@livingston.com' with 'unsubscribe portmaster-users' in the body of the message. Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>