Re: (PM) location setup & dialout killing ether0 (PM3)

Thomas C Kinnen (tkinnen@livingston.com)
Fri, 30 Apr 1999 11:08:50 -0700

James Hamilton wrote:
>
> Hello, I've got a PM3 that I've set up for dialout. Every time I call my
> Netgear ISDN router ether0 quits talking so I have to do an
> ifconfig down then ifconfig up to reset it. It seems to only affect
> ether0, if I have 2 logins to the PM3 they can still talk locally to
> eachother. My location looks like:
>
> Location: jamesh Type: Manual
> Destination: 198.59.115.158 Netmask: 255.255.255.0
> Local IP: 198.59.115.110

Note, Your local IP and the destination are on the same network and subnet.
That coupled with the netmask is probably over riding the default gateway
route and sending all the outbound traffic to the location.

-- 
Thomas C Kinnen - <tkinnen@livingston.com> <tkinnen@sobhrach.com>
[RADIUS Test Engineer] - LUCENT Technologies RABU
"All of the opinions stated above are my own and not my employer's,
unless they were given to me by my employer"




-
To unsubscribe, email 'majordomo@livingston.com' with
'unsubscribe portmaster-users' in the body of the message.
Searchable list archive: <URL:http://www.livingston.com/Tech/archive/>